This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
why_does_the_map_path_appear_to_be_in_the_wrong_place_even_though_i_entered_the_correct_grid_square_for_the_dx_call [2019/11/12 19:34] vk2az |
why_does_the_map_path_appear_to_be_in_the_wrong_place_even_though_i_entered_the_correct_grid_square_for_the_dx_call [2019/11/12 19:38] (current) vk2az |
||
---|---|---|---|
Line 3: | Line 3: | ||
VKSpotter works out bearings and distances in the following way: | VKSpotter works out bearings and distances in the following way: | ||
- | If the station you spotted is not a member of VKSpotter, then it will use the center of the grid square you supplied. | + | * If the station you spotted is not a member of VKSpotter, then it will use the center of the grid square you supplied. |
- | + | | |
- | The same is true if they are a member, but you supplied a grid square that is different to the one supplied by the member. | + | |
- | + | | |
- | If the station you spotted is a member of VKSpotter and they have not set a latitude and Longitude, it will use the center of the grid square supplied by the member or the one you supplied if it is different. | + | |
- | + | ||
- | If the station you spotted has set a latitude and longitude all bearings and distances will be calculated from that, unless the grid you spotted is different to the one supplied by the member. | + | |
Simple really :-) | Simple really :-) | ||
**So the answer to the question is:** | **So the answer to the question is:** | ||
- | The DX station is a member and they have set their latitude and longitude incorrectly. | + | The DX station is a member and you supplied the same grid square as they have set, but they have set their latitude and longitude incorrectly. |
+ | |||
+ | Now go tell them nicely how to change their Lat Long. | ||